NETGEAR genie Advanced Home
35
N900 Wireless Dual Band Gigabit Router WNDR4500
LAN Setup
The LAN Setup screen allows configuration of LAN IP services such as Dynamic Host
Configuration Protocol (DHCP) and Routing Information Protocol (RIP).
The router is shipped preconfigured to use private IP addresses on the LAN side and to act
as a DHCP server
. The router’
s default LAN IP configuration is:
• L
AN IP address. 192.168.1.1
• Subnet mask. 255
.255.255.0
These addresses are part of the designated private
address range for use in private networks
and should be suitable for most applications. If your network has a requirement to use a
different IP addressing scheme, you can make those changes in the LAN Setup screen.
To change the LAN settings:
Note: If you change the LAN IP address of the router while connected
through the browser, you will be disconnected. You will have to open
a new connection to the new IP address and log in again.
1. Select Advanced > Setup > LAN Setup to display the following screen:
2. Enter the settings that you want to customize. These settings are described in the following
section, LAN Setup Screen Settings.
3. Click Appl
y to save your changes.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
