NETGEAR WNDR4500v2

NETGEAR genie Advanced Home
37
N900 Wireless Dual Band Gigabit Router WNDR4500v2
LAN Setup
The LAN Setup screen allows configuration of LAN IP services such as Dynamic Host
Configuration Protocol (DHCP) and Routing Information Protocol (RIP).
The router is shipped preconfigured to use private IP addresses on the LAN side and to act
as a DHCP server. The router’s default LAN IP configuration is:
• LAN IP address. 192.168.1.1
• Subnet mask. 255.255.255.0
These addresses are part of the designated private address range for use in private networks
and should be suitable for most applications. If your network requires a dif
ferent IP
addressing scheme, you can change these settings in the LAN Setup screen.
 To change the LAN settings:
Note: If you change the LAN IP address of the router while connected
through the browser, you are disconnected, and must open a new
connection to the new IP address and log in again.
1. Select Advanced > Setup > LAN Setup.
2. Enter the settings that you want to customize. These settings are described in the following
section, LAN Setup Screen Settings.
3. Click Apply to save your changes.