Optional Step 5: Install an SFP Transceiver Module
The following optional procedure describes how to install an optional SFP transceiver module into one of
the SFP ports of the switch.
Contact your NETGEAR sales office to purchase these modules. If you do not want
to install an SFP module, skip this procedure.
Note
To install an SFP transceiver module:
1. Insert the transceiver into the SFP port.
2. Press firmly on the flange of the module to seat it securely into the connector.
The following figure shows model XS708T.
Installation
24
8-Port, 12-Port, and 16-Port Gigabit Smart Managed Pro Switch
To Next Page
Loading...
