NETGEAR XS724EM

Enable Port Mirroring
Port mirroring lets you mirror the incoming (ingress) and outgoing (egress) traffic of one or more ports (the
source ports) to a single predefined destination port.
To enable port mirroring:
1. Connect your computer to the same network as the switch.
You can use a WiFi or wired network connection, or connect directly to a switch that is off-network using
an Ethernet cable.
2. Launch a web browser.
3. In the address field of your web browser, enter the IP address of the switch.
The login page displays.
4. Enter the switch password.
The default password is password. The password is case-sensitive.
The Switch Information page displays.
5. Select System > Monitoring > Mirroring.
The Port Mirroring Configuration page displays.
6. In the Destination Port menu, select the destination port.
You can select a single destination port only.You cannot select a destination port that is a member of
a LAG.
7. In the Source Port section, select one or more source ports by selecting the check boxes that are
associated with the port numbers.
You can select more than one source port.You cannot select a source port that is a member of a LAG.
8. In the Mirroring menu, select Enable.
By default, mirroring is disabled.
9. Click the Apply button.
Your settings are saved.
Manage and Monitor the Switch
58
12- or 24-Port 10-Gigabit/Multi-Gigabit Switch Models XS512EM and XS724EM