Factory Default Settings
You can return the switch to its factory settings. Use the end of a paper clip or some other similar object to
press and hold the Factory Defaults button on the front panel of the switch for four seconds.The switch
resets and returns to the factory settings that are shown in the following table.
Table 7. Factory default settings
SettingFeature
passwordSwitch password
192.168.0.239 (if the switch is not connected to a network with a DHCP server)IP address
255.255.255.0Subnet mask
EnabledDHCP mode
EnabledUPnP
EnabledBonjour
EnabledNSDP
EnabledIGMP snooping
None configuredLAGs
Disabled. If enabled, by default, all ports are members of VLAN 1.VLANs
Disabled. If enabled, by default, the Class of Service (CoS) value is 6.Voice VLAN
Enabled802.1p/DSCP-based QoS
DisabledPort-based QoS
DisabledRate limiting
DisabledBroadcast filtering
EnabledLoop prevention
DisabledPower saving mode
AutonegotiationPort speed
DisabledFlow control
DisabledPort mirroring
Factory Default Settings and Technical Specifications
65
12- or 24-Port 10-Gigabit/Multi-Gigabit Switch Models XS512EM and XS724EM
To Next Page
Loading...
