NETGEAR XS724EM

Basic Technical Specifications
The following table shows the basic technical specifications of the switch.
For more specifications, see the data sheet that you can download by visiting downloadcenter.netgear.com.
Table 8. Basic technical specifications
DescriptionFeature
IEEE 802.3 Ethernet
IEEE 802.3i 10BASE-T
IEEE 802.3x Full-Duplex Flow Control
IEEE 802.3u 100BASE-TX
IEEE 802.3ab 1000BASE-T
IEEE 802.3z Gigabit Ethernet 1000BASE-SX/LX
IEEE 802.3bz 2.5GBASE-T and 5GBASE-T
IEEE 802.3an 10GBASE-T
IEEE 802.3ae 10-Gigabit Ethernet Over Fiber (10GBASE-SR, 10GBASE-LR,
10GBASE-LRM, 10GBASE-ER, 10GBASE-LX4)
IEEE 802.3az Energy Efficient Ethernet (EEE)
IEEE 802.1p Class of Service
IEEE 802.1Q VLAN tagging
IEEE standards
Model XS512EM:
Ten RJ-45 10-Gig/Multi-Gig Ethernet ports numbered 1 through 10 that support 10G,
5G, 2.5G, 1G, and 100M.
Two combo ports.You can use either ports 11T and 12T as 10-Gig/Multi-Gig Ethernet
ports for 10G, 5G, 2.5G, 1G, and 100M connectivity or ports 11F and 12F as SFP+ slots
for optional fiber or copper transceiver modules.
Network interfaces
Model XS724EM:
Twenty-two RJ-45 10-Gig/Multi-Gig Ethernet ports numbered 1 through 22 that support
10G, 5G, 2.5G, 1G, and 100M.
Two combo ports.You can use either ports 23T and 24T as 10-Gig/Multi-Gig Ethernet
ports for 10G, 5G, 2.5G, 1G, and 100M connectivity or ports 23F and 24F as SFP+ slots
for optional fiber or copper transceiver modules.
For 100 Mbps, use a Category 5 (Cat 5) or higher-rated cable.Network cable
For 1 Gbps, 2.5 Gbps, or 5 Gbps, use a Category 5e (Cat 5e) or higher-rated cable.
For 10 Gbps for up to 55 meters (180 feet), use a Category 6 (Cat 6) or higher-rated
cable.
For 10 Gbps for more than 55 meters (180 feet), use a Category 6A (Cat 6A) or
higher-rated cable.
Factory Default Settings and Technical Specifications
66
12- or 24-Port 10-Gigabit/Multi-Gigabit Switch Models XS512EM and XS724EM