Netum E800 - Scanner Operation and Status; Charging the Scanner

(4)
Charge the scanner
Warning Tone
· Red Light - Charging
· Green Light - Fully charged
· Improtant Notes: DC PlugV: 5V; A>500mA
Connect Scanner with your host through USB cable (provided by Netum) or
take a DC plug and charge it on an electrical wall outlet.
Low battery warning - 2 beeps, LED in red �lashing twice
Running out of battery - 5 beeps, LED in red �lashing 5 times
Scanning will not read any barcodes when it’s running out of battery.
Get Battery Volume
By scanning below command barcode will get rough battery volume.
Firmware Version
Firmware version will be displayed by scanning “$SW#VER”.
%BAT_VOL#
$SW#VER