Factory Defaults
Scanning the following barcode will restore the scanner to the factory.
Scanner will power off after you scanning Factory Restore.
Barcode Programming
Netum barcode scanners are factory programmed for the most common
terminal and communication settings. If you need to change these settings,
programming is accomplished by scanning the bar codes in this guide. An
asterisk (*) next to an option indicates the default setting.
Important Notes :
Many command barcodes only work in a particular transmission mode. Please
pay attention to below symbol when you scanning the command barcodes.
Command barcodes only apply to transmit characters through Bluetooth .
Command bacodes only apply to transmit characters through USB Dongle .
Command bacodes only apply to
transmit characters through USB cable .
Connect scanner to a host device
Characters can be transferred from scanner to your device through USB cable,
USB Dongle or Bluetooth, choose one of the connection ways to get started:
USB Wired Connection
1)Connect scanner with your computer via type-C cable.
2) Setup keyboard language. For example if you use French keyboard, just scan
“French keyboard” from keyboard language setcion in page 9.
3) Locate cursor on the place where you want scanner to output the characters
then you can start to scan.
Factory Restore
(5)
%#IFSN0$B
To Next Page
Loading...
Need help?
General
