Netum NT-1203 - Repeated code detection setting

10
Repeated code detection setting
Setting code
Function
Description
Enable repeated code
detection
Enable repeated
code detection.
Note: this setting
will be
automatically saved
and remain
effective after
power failure.
When this function
is activated, the
scanner will give an
error alarm with 5
beeps and
automatically
cancel the last
repeated code if a
repeated code is
scanned.
Disable repeated code
detection
Disable repeated
code detection.
Note: this setting
will be
automatically saved
and remain
effective after
power failure.
The above detecting time can be adjusted by scanning the following codes:
(default: 6 seconds)
Enter setting
Set detecting time 6 seconds
Set detecting time 5 seconds
Set detecting time 4 seconds
Set detecting time 3 seconds
Set detecting time 2 seconds
Set detecting time 1 seconds