If you are heading for a working area which lies outside the signal range, you
may activate store mode of the scanner. Under store mode, all scanned data
will be stored directly into the buffer memory of the device. Furthermore, the
data entries will be permanently saved in the buffer memory prior to the
manual upload into the working station, so that you may upload them time and
again to your liking.
1. By scanning the following barcode, the store mode will be activated
2. By scanning the following barcode, all data in the buffer memory will be
deleted
3.By scanning the following barcode, all data entries in the buffer memory can
be uploaded after reconnecting to the working station .
4. By scanning the following barcode, the gross quantity of the uploaded data
entries will be summarised .
Working Mode (Only apply for wireless mode)
- 5 -
Store Mode
Clear All Memory
Uploading the Data
Summarising of Uploaded Data Entry Quantity
To Next Page
Loading...
Need help?
General
