Netum NT-1698W - Scanning Mode Configuration; Trigger and Continuous Modes; Terminator Configuration

Scanning this bar code will enable the scanner to enter manual trigger mode.
Scanning Mode
The scanner provides a shortcut for con�iguring the terminating character
suf�ix to CR or CRLF and enabling it by scanning the appropriate barcode
Terminator
Trigger Mode (Default)
This mode enables the engine to scan/capture, decode and transmit over and
over again.
Continuous Mode
- 4 -
Trigger Mode
Continuous Mode
Add Enter as terminator
Add TAB as terminator
No terminator