Serial Command Short Form
help ?
get id g i
get state g s
[get / set] voltage [150..500] [g / s] v
[get / set] pulse width [80..1000] [g / s] p w
[get / set] pulse repeat [1..10000] [g / s] p r
[get / set] pulse deadtime [1..1000] [g / s] p d
[get / set] arm_timeout [0…60] [g / s] a
[get / set] hwtrig_term [1/0] [g / s] hwt
[get / set] hwtrig_mode [1/0] [g / s] hwm
[get / set] emode [1/0] [g / s] e
[get / set] mute [1/0] [g / s] m
[get / set] absent_temp [1..0] [g / s] at
get fault g f
get fault_active g fa
get fault_latch g fl
get fault [latched / current] <type> g f [l / c] <t>
get temperature <sensor> g temp <s>
get triggersafe g ts
[get / set] pat_enable [1/0] [g / s] pat
[get / set] pat_wave [011100…0] [g / s] w
set pat_append [111000…0] s wa
set fault none s f n
arm a
Arm A
disarm d
safe S
pulse p
Reset_config Reset
reset r
To Next Page
Loading...