To Next PageTo Next PageWhy does the limit switch shut down my Newmac CL 86-96C Furnace?
If the limit switch shuts down your Newmac Furnace, it's often due to insufficient return air supply or an obstruction, such as a rug covering a supply air grill. Ensure adequate airflow to prevent this issue.
What to do if the draft fan does not operate on my Newmac Furnace?
If the draft fan on your Newmac Furnace isn't working when the solid fuel thermostat is turned up, check the following: 1. Power supply. 2. Voltage on the secondary side of the control relay transformer. 3. Wiring connections. 4. Voltage at the fan motor. If all these check out, the fan itself may be defective.
Details on setting and using thermostat heat anticipators for optimal furnace operation.
Instructions for operating the combination unit, including general care, fuel, controls, and safety.
Guidelines for operating the oil burner, covering general care, fuel, and safety precautions.
Instructions for operating the furnace with wood, including combustion air and power failure.
Advice for efficiently and safely burning coal in the furnace.
Information on installing air cooling equipment and converting models for AC use.
Wiring diagrams for AC integration and CL series furnaces.
Details on electrode settings, burner insertion, sleeve position, and dimensional data.
Specifications for gas burners, installation steps, and wiring diagrams.
Assembly diagrams and parts lists for various furnace models (CL115-170C, CL86-96C, CL115-170G, CL86-96G).
Information on wood moisture, causes of rot, prevention, and the importance of drying firewood.
Definition, causes, and hazards of creosote buildup and chimney fires.
Recommendations for regular maintenance and proper unit operation.
Section for recording initial test results and service information after installation.
Details of the warranty program, including heat exchanger coverage, notes, and general conditions.
General
