To Next PageTo Next Page
Need help?Do you have a question about the Newmac CL 86C and is the answer not in the manual?
Provides essential guidelines and specifications for furnace operation and setup.
Details the procedures and requirements for installing the furnace correctly.
Specifies the requirements for proper ductwork sizing and installation.
Instructions for mounting the WMO-1 switch on the burner plate.
Procedures to test the functionality of the WMO-1 switch.
Guidelines for routine maintenance and cleaning of the WMO-1 switch assembly.
Covers routine care for the oil burner, fuel, and heating plant.
Explains the operation of the burner controls and thermostat.
Provides advice and procedures for safely and effectively burning coal.
Covers daily and monthly maintenance procedures for the furnace.
Routine cleaning tasks performed on a daily basis.
Monthly inspection and cleaning of furnace components.
Instructions for operating the furnace during a power outage.
Procedures to follow in case of a soot fire.
Steps to take if the furnace experiences a runaway fire.
Guidelines for installing gas burners, including piping and mounting.
Wiring diagrams for gas burners.
Guidance on preparing wood for efficient and safe burning.
Information on wood moisture content and its impact.
Explains the importance of drying wood to prevent issues like creosote.
Definition and properties of creosote and its hazards.
Recommendations for thorough cleaning at the end of each heating season.
Advice on wood burning, oil burning, and off-season operation.
Section for recording installer details and appliance test results.
Details the warranty terms and conditions for the heating unit.
Outlines the requirements for maintaining warranty validity.
Records for initial testing and operational information by the installer.
Crucial steps to prevent damage to the appliance and ensure safe operation.
Procedures to follow during an electrical power failure.
Periodic cleaning and seasonal maintenance advice.
Guidance on operating the furnace with different fuels.
Explains how green wood contributes to creosote formation.
Instructions for preparing wood for optimal burning.
Information on wood moisture content and its impact.
Step-by-step guide for starting the gas burner.
Guidelines for installing gas burners, including piping and mounting.
Wiring diagrams for gas burners.
Instructions for loading fuel into the firebox.
Instructions on how to shake the grates for optimal combustion.
Daily maintenance procedures for ash removal and grate care.
Guidelines for operating the furnace using wood as fuel.
Tips and techniques for efficient and safe coal heating.
Routine care for the oil burner, including cleaning and lubrication.
Explanation of burner controls and thermostat operation.
Instructions for shutting down the unit during summer months.
Step-by-step guide for starting the oil burner.
Steps to safely remove grates from the firebox.
Steps to correctly install grates into the firebox.
Procedures to test the WMO-1 switch for blocked vents.
Steps for cleaning and maintaining the WMO-1 switch.
Troubleshooting common issues with the WMO-1 switch.
Key considerations for duct installation.
Instructions for installing a humidifier.
Specific settings for fan and limit controls based on model.
Step-by-step guide for starting the mixed fuel furnace.
General instructions and specifications for mixed fuel furnaces.
General
