5
Table 1 – Model 2835-C Display Annunciators
Annunciator Comment
CH A The display is showing Channel A information.
CH B The display is showing Channel B information.
Blinking indicates that the meter is making
measurements.
DC Meter is set to make DC signal measurements.
INTG Meter is set to make INTEGRATED signal
measurements.
P-P Meter is set to make Peak-to-Peak signal
measurements.
SNGL Meter will make only one measurement per front
panel or external trigger.
CONT Meter will continuously make measurements until
stopped.
PULSE Meter is set to make pulse energy measurements.
ANLG Analog signal filtering is on.
DIG Digital signal filtering is on.
SHIFT Indicates that the next key press will execute a blue
key function.
MENU Meter and display are in menu mode. Measurement
is stopped.
STORE Meter is logging measurements into memory, i.e.
data logging.
USRCAL User (versus calibration module) has supplied the
detector responsivity in use.
EXT External trigger input is enabled.
AUTO Automatic signal gain ranging is on.
ZERO Background signal subtraction (zeroing) is on.
ATTN The responsivity in use includes the affect of the
detector’s attenuator.
2.3 Top Level Key Functions
Operating controls for the Model 2835-C are found on both the front and rear
panels of the Model 2835-C. For measurement operation, only the front panel
controls are used. Rear panel controls are used for AC line power setup,
Section 2.5. The front panel key pad of the Model 2835-C, Figure 3, provides
quick access to measurement functions and menu access to advanced fea-
tures and setup parameters. Most of the keys on the front panel only affect
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
