44
Section 5
Command Reference
5.1 Model 2835-C Remote Interface Commands
The Model 2835-C remote commands can be divided into two groupings:
i. Device Independent Commands, Section 5.2
ii. Device Dependent Commands., Section 5.3
Table 25 lists the Device Independent Commands supported by the 2835-C
while Table 26 lists the Device Dependent Commands supported the 2835-C.
Following these tables are the detailed presentations of each command and its
syntax and an example of its use.
Table 25 – Device Independent Status Commands
Command Command Name
*CAL? Calibration Query
*CLS Clear Status
*ERR? Error Query
*ESE Event Status Enable
*ESE? Event Status Enable Query
*ESR? Event Status Register Query
*IDN? Identification Query
*IST? Individual Status Query
*OPC Signal When Operation Complete
*OPC? Operation Complete Query
*PRE Parallel Poll Enable
*PRE? Parallel Poll Enable Query
*RCL Recall Device Configuration
*RST Software Reset
*SAV Save Device Configuration
*SRE Service Request Enable
*SRE? Service Request Enable Query
*STB? Status Byte
*TST? System Test
*WAI Wait To Continue
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
