Newport LDC-3706 Series - Page 73

December 2019 61 LDC-3706 Series Laser Controller
NAME FUNCTION INSTrument
setpoint.
SOURce[1]:RESistance:SPOint?
Report the TE controller resistance
setpoint.
TEC
SOURce:RESistance:TOLerance <nrf>
Set the TEC resistance tolerance.
See status section: “out of
tolerance” bit in condition reg.
TEC
SOURce:RESistance:TOLerance?
Report the TEC resistance tolerance
setting.
TEC
SOURce[1]:TEMPerature:AM[:STATE] <nrf>
Enable or disable TE controller
analog temperature modulation.
TEC
SOURce[1]:TEMPerature:AM[:STATE]?
Report analog temperature
modulation state.
TEC
SOURce[1]:TEMPerature:LCONstants:DERivative <nrf>
Set the “D” term for the TEC
controller PID control loop.
TEC
SOURce[1]:TEMPerature:LCONstants:DERivative?
Report the “D” term for the TEC
controller PID control loop.
TEC
SOURce[1]:TEMPerature:LCONstants:INTegral <nrf>
Set the “I” term for the TEC
controller PID control loop.
TEC
SOURce[1]:TEMPerature:LCONstants:INTegral?
Report the “I” term for the TEC
controller PID control loop.
TEC
SOURce[1]:TEMPerature:LCONstants[:GAIN] <nrf>
Set the “P” term for the TEC
controller PID control loop.
TEC
SOURce[1]:TEMPerature:LCONstants[:GAIN]?
Report the “P” term for the TEC
controller PID control loop.
TEC
SOURce[1]:TEMPerature:PROTection:LOW <nrf>
Set TE controller low temperature
limit.
TEC
SOURce[1]:TEMPerature:PROTection:LOW?
Report TE controller low
temperature limit.
TEC
SOURce[1]:TEMPerature:PROTection[:HIGH] <nrf>
Set TE controller high temperature
limit.
TEC
SOURce[1]:TEMPerature:PROTection:HIGH?
Report TE controller high
temperature limit.
TEC
SOURce[1]:TEMPerature:SPOint <nrf>
Set TE controller temperature
setpoint.
TEC
SOURce[1]:TEMPerature:SPOint?
Report TE controller temperature
setpoint.
TEC
SOURce[1]:TEMPerature:TOLerance <nrf> Set TEC temperature tolerance. TEC
SOURce[1]:TEMPerature:TOLerance? Report TEC temperature tolerance. TEC
SOURce[1]:TOLerance:TIME <nrf>
Set duration for temperature to be
stable.
TEC
SOURce[1]:TOLerance:TIME?
Report duration for temperature to
be stable.
TEC
SOURce[1]:STABle?
Report if temperature has settled
to user-specified temperature and
time window.
TEC