EN 46
HOW DO I CHOOSE THE CORRECT AUDIO OUTPUT?
In the Audio Output settings menu, when you select a speaker, you will
see two output options: PCM and RAW.
With PCM output, the audio source is processed and decoded before it
is sent to the speakers. It has wide compatibility, but the sound quality
will be altered when compared to the raw audio. PCM is the ideal
choice if your speaker does not support end-line decoding, or if you
prefer more processed sound quality.
With RAW output, no processing or decoding is performed on the
audio output by the projector, allowing the audio to retain much of the
original sound quality. Generally, RAW output is the optimal choice if
you have a receiver that is capable of performing the decoding itself.
WHAT IF I CANNOT TURN ON THE PROJECTOR?
Please check that the device is properly connected to a power source.
Press the power button on the device to turn the device on.
If the projector is hot, please wait for it to cool down before restarting it.
If these options do not help resolve the issue, please contact NexiGo
customer support at cs@nexigo.com.
WHAT IF THE DEVICE DOES NOT SHOW AN IMAGE?
Power off the device and unplug the power cable. Let the device sit for
one minute to allow the capacitors to discharge. Plug it in again after
one minute and power on the device.
The device providing the input source for the projector may not be
powered on or connected properly. Please unplug the input device and
then reconnect it, ensuring that the connection is solid.
The input source may be incorrect. In the projector menu, navigate to
Settings > Input source and select the correct input source you want to
connect.
WHAT IF THE IMAGE IS BLURRY?
Check if the projector is focused properly. In the projector menu,
navigate to Settings > Display to adjust the focus.
Ensure the content is presented in high definition (1080p or higher).
Non-HD content may appear blurry on a large display.
To Next Page
Loading...
