Nexo GEO M10

GEO M10 HARDWARE SETUP PROCEDURE Page 43/79
IMPORTANT
Maximum GEO M10 quantity for flown vertical cluster with GMT-LBUMPM10 is 12 (and
eventually less).
Please check NS1 for mechanical Safety Working Load and acoustic computations.
IMPORTANT
Motor hoist must be rated to support entire cluster weight. Please check configuration
in NS1 for proper motor hoist rating
Procedure
GMT-LBUMP10 can be flipped front and back depending if its connects to GEO M10 Right or Left.
- When connecting GEO M10 Left, bumper front is on the “A” hole index side
- When connection GEO M10 Right, bumper front is on the “G” hole index side
GEO M10 Left
- Position first GEO M10 so that Autorig
TM
is at the bottom
- Position bumper (“A” hole at front) on top of first GEO M10
- Remove the two BL820 quick release pins from their side storage position, and the BL825 quick
release pin of rear bumper link bar.
- Connect bumper front points to GEO M10 with the BL820 quick release pins
- Connect the bumper link bar (0° position) to GEO M10 rear rigging plate (hole marked “bumper”) Lock
with the quick release pin BL0825.
GEO M10 Right
- Position GEO M10 so that Autorig
TM
is at the top and set in automatic lock position
- Position bumper (“G” hole at front) on top of first GEO M10
- Remove the the BL825 quick release pin of rear bumper link bar.
- Connect bumper front points to GEO M10, front points will lock automatically
- Connect the bumper link bar (0° position) to GEO M10 rear rigging plate (hole marked “bumper”) Lock
with the quick release pin BL0825.