QUICK START
(7) Rear end mounting holes
If the NXAMP is to be rack mounted and transported frequently, be sure to support the
rear end of the unit with mounting hardware that matches the size of the rack used.
Basic functions
Reset
You can reset the unit without powering off by simultaneously depressing buttons A, B &
“Select CH1” for 3 seconds at least.
(for 3 seconds)
Selecting cabinet family
Simultaneously depressing A & B buttons at power up or during device RESET accesses the
system change menu. Keep the A & B Buttons held until all LEDs are off (approx. 20
seconds). This will allow the selection of any cabinet in any family. Using the rotary
encoder, scroll through the configurations and press “B” to load the required settings.
Select your cabinet set-up
In the ‘Options’ menu, choose “Systm Config”, and you will be able to choose among the
different set-ups within the same cabinet family. (i.e. you don't have to modify the
amplifier to cabinet wiring).
PAGE 16 OF 80
To Next Page
Loading...
Need help?
General
