NXWIN4 SOFTWARE FOR NXAMP4X1 FIRMWARE UPGRADE
NB: Even if you plan to use the serial port for upgrade, your computer must have an
Ethernet port for the software to set up correctly.
Then through the start menu, double-click on Programs> Nexo> Firmware Update>
NXwin4. The Nexo loader will appear on the screen of the computer. Use the “Browse”
button to select the firmware file (the extension is .dld).
Then choose the serial port connected to the NXAMP4x1 Powered TDcontroller (note: only
the detected and available serial port appears in the list), and finally press the download
button. The following splash window should pop up on screen:
To upgrade NXAMP4x1 (fitted with NXES104 board) through the Ethersound network,
choose the Ethersound port interface and select the network card connected to the
Ethersound network. Select device that you want to upgrade.
Note: the firmware of the Ethersound board will be upgraded at the same time if included
inside the LOAD file (.DLD file).
PAGE 62 OF 80
To Next Page
Loading...
Need help?
General
