Page 40/82 PS SERIES HARDWARE SETUP PROCEDURE
7.4.2 PS on speaker stand or on RS15 horizontally
Required items
1 x Speaker stand diameter 35mm (K&M 213 or equivalent);
Or NEXO PS pole stand (STDPS) for mounting on top of SubBass;
IMPORTANT (SPEAKER STAND)
- Speaker stand must be rated for PS cabinet weight;
- Speaker stand must always be installed on a horizontal surface;
- Stand height and footprint must be defined to prevent assembly from collapsing;
- Ensure that audience is not allowed within a safety area which radius is equal or higher
than assembly height.
Procedure
Lift PS on speaker stand or on RS15 with STDPS pole stand;
Ensure that all screws are properly tight;
Test steadiness of the assembly by pushing in all directions
To Next Page
Loading...
