44
Previewing a Route Using Demo Mode
Demo mode enables you to preview a route. This mode involves manually setting an
origination and destination points. When you tap Go, the program simulates vehicle
progress and announces turn-by-turn instructions associated with the route you set. A
GPS signal is not necessary to use this mode.
To preview a route using the Demo mode
1. Use the SET ORIGIN feature to manually set the origination point. (See Setting
Origin on page 43.)
2. Tap MENU > SETTINGS. The Settings screen opens. (See below.)
Settings screen
3. Tap DEMO. In the Demo screen, tap DEMO ON.
4. Tap OK. The system returns to the main map display. Note that the program
periodically displays DEMO on the lower portion of the screen to indicate that
Demo mode is on.
5. Tap MENU > GO TO DESTINATION and set a destination to a particular location.
In the Destination Confirmation screen, tap GO to start turn-by-turn instructions
(see example below). Alternatively, tap SAVE & GO if you first want to save the
destination as a location in the Favorites list before getting turn-by-turn instructions
to the selected location.
6. The voice guidance system will begin announcing the first maneuver while the
screen displays route and turn-by-turn instructions. For more information on View
options, see Selecting and Working with Turn-By-Turn Views on page 19.
7. To stop the turn-by-turn instructions, tap MENU > SETTINGS, and then tap the
CANCEL ROUTE button.
8. To exit Demo mode, tap MENU > SETTINGS > DEMO. In the Demo screen, tap
the DEMO ON box to clear (deselect) the option, and then tap OK.
To Next Page
Loading...
Need help?
General
