DASH CAM SETTINGS (CONTD.)DASH CAM SETTINGS (CONTD.)
Video menu continued:
3. Parking Mode
There is only one method of using parking Mode, which is by using a ‘Permanent Live’.
This means that there is always 12Vdc being supplied to the Dash Cam. This can either by
using a 12Vdc outlet that does not power off when the vehicles ignition is turned off or by using
the Nextbase Hardwire Kit which has been installed using a permanent live fuse location.
Once Parking Mode has been turned on, the Dash Cam will enter standby mode when there is
no physical movement detected for a 5 minute period.
Should physical movement of the vehicle be detected, the Dash Cam will power on and start
recording a 1 minute protected video and then will continue to record normally until there is no
physical movement detected for a 5 minute period.
4. G Sensor
Turn off or adjust the sensitivity of the built in G Sensor. The G Sensor detects forces which
will automatically protect the current recording in event of a collision.
Note:
- This does not affect Parking mode sensitivity.
Options: High, Medium, Low and Off
Default Setting: Medium
37
To Next Page
Loading...
