19
e)Press ► to position the cursor under the next letter and repeat step d.
f) Repeat steps d-e to create a new name up to thirteen characters long. Use the blank space
to delete characters left over from the original preset name if necessary.
6. Press ENTER. ‘NAME SAVED’ will appear on the Display for a couple seconds. The Display
will return to the Zone Naming Window with ZONE [3] now NAMEd as ENTRY.
7. Repeat steps 2-6 for zones 2-18 as needed.
8. When all Inputs have been named, press MENU. UPDATING KEYPADS will appear on the
Display for a few seconds. The Display will return to the default Tuner Preset Window.
9. Use the GROUP and SELECT buttons on any K-22 Keypad to scroll through the Zone Group
Menu to confirm programming. Make corrections as necessary.
10. Check all K-22 Keypads to confirm Update.
Input Level Trim
Different source components can have different output levels. When switching inputs, this will
cause some sources to sound louder than others. The Input Level Trim feature provides a
method of ‘balancing’ the relative loudness of the different sources. Each input can be attenuated
up to 15db in 1db increments from unity gain.
To properly adjust trim, all sources must be connected to their appropriate inputs on the C-6
Controller. They must all be loaded with program material (Radio station, CD, DVD, Video Tape
etc.) and playing. When selecting program material, choose material with similar characteristics.
That is, don’t have the Tuner set to an easy listening station while the CD player is playing high
octane shred metal. Consider also the dynamics of movies from DVD and Satellite where the
sound track can range from low level dialogue to sound of jet engines and explosions. To set
Input Level Trim:
1. Load and play all sources as recommended above.
2. Press SELECT on the Programming Keypad to cycle through all inputs. Make a mental note of
which sources are ‘louder’ than others.
3. Press MENU to enter the Setup Menu. INPUT LEVEL TRIM will be listed in the menu options.
Press ▼ on the Navigation Array to scroll through the menu options to Input Level Trim. When
► appears to the left of Input Level Trim, Press ENTER. The Display will change to the Input
Level Trim Window.
4. The Input Level Trim Window will default to [TUNER].
5. Press ► in the Navigation Array. The Programming Brackets [] will move to LEVEL: [0dB].
6. Press ▲ and ▼ in the Navigation Array to adjust the input level as needed.
NOTE: Input Level Trim adjustments cannot be monitored while in Setup Menu. The settings
must be stored and the Controller must be in a normal use mode to cycle through the inputs to
monitor changes in Input Trim Levels.
7. Press ◄ or ► to return the programming brackets to [TUNER] (or current input).
8. Press ▲ or ▼ to navigate to the previous or next input.
9. Repeat steps 5-8 for Inputs 1-5.
10. Press ENTER when the desired trim levels have been set. ‘SETTINGS SAVED’ will appear
on the Display for a couple seconds. The Display will return to the Setup Menu with Input Level
Trims adjusted.
11. Using the SELECT button on any keypad, scroll through the sources to confirm equal relative
audio levels from all sources. Adjust as needed.
12. Press MENU to return to the default Tuner Preset Window.
Page/Mute
The C-6 can be used for whole-house paging when used with an appropriately featured
telephone system or microphone preamp having a line level audio output and 12VDC control
output. It also has a zone mute function that can be used to mute selected zones with a 12VDC
control input. Both features, Page and Mute have a variable timeout of 1-60 seconds, to set how
long the selected source will be interrupted when triggered by a 12VDC pulse. To program Page
and Mute functions:
To Next Page
Loading...
