Positioning remote control
To ensure good unit function, avoid installing the remote
control under the following conditions:
■
Behind a curtain or other covered areas.
■
Where it can be met by air blown out from the climate
unit.
■
On poorly insulated walls.
■
In direct sunlight.
■
Where it can be subjected to electrical or magnetic
interference.
■
Where there are obstructions between the remote
control and the climate unit.
Position on the wall:
■
Hold the remote control in the desired position.
■
Check that the remote control communicates with the
climate unit from this preset position.
■
Secure the holder in the wall with two screws and hang
up the remote control.
Reset to factory setting
The indoor unit can be reset to factory settings using the
remote control. To do this, set the remote control as
follows:
■
TiO
2
air cleaner ( ): ON
■
Night program ( ): OFF
■
High power-program ( ): OFF
■
Operating mode ( or ): AUTO
■
Air deflector ( ): AUTO
■
Set point temperature ( / ): 10 °C
Hold the buttons "FAN" and "iFEEL" pressed for at least
five seconds, with the remote control aimed towards the
indoor unit IR receiver.
If the unit has received the command, four beeps are
sounded as confirmation. When you have heard the
beeps, restart the climate unit to complete the reset.
Coding remote control for
multiple indoor units
Caution
Ignore this section if you only have one indoor
unit as this describes how to connect your re-
mote control to several indoor units.
In premises with multiple indoor units all remote controls
can control all indoor units if these have retained default
setting (code 1). To connect a remote control to one or
more specific indoor units, one of the following codes
can be selected. The remote control can only control in-
door units with the same code, however, you can select
to have more than one indoor unit with that code.
NOTE
The indoor unit and remote control must not
be live when adjusting the DIP switches.
Location of DIP switches
Indoor unit
1.
Remove the cover that covers the terminal block.
AG-WL10Chapter 6 | Remote control14
6 Remote control
To Next Page
Loading...
