Nibe AG-WL10 series - 5 Installation; Installation Instructions

Installation instructions
1.
AG-WL10 can be connected in six directions: down-
wards, backwards or sideways on each side of the
unit.
2.
AG-WL10 can either be installed standing on the
floor or suspended from the wall with the brackets
provided.
3.
Remove the bracket from the rear of the unit.
N.O
4.
When installing with bracket, place the bracket on
the wall and screw a screw into the centre hole. Align
the bracket and mark the holes as illustrated below,
two are optional. The dotted line indicates the outer
dimensions of the indoor unit.
375 375
24
577
375 mm375 mm
24 mm
577 mm
Optional
Optional
Centre hole
9Chapter 5 | InstallationAG-WL10
5 Installation