Transport
Take care when lifting and moving the indoor unit.
Assembly
We recommend that this climate unit be installed by an
authorised technician in accordance with the supplied
installation instructions.
NOTE
■
Do not install this climate unit where there
are flue gases, flammable gases or a lot of
moisture, e.g. in a greenhouse.
■
Do not install this climate unit where there is
equipment that generates too much heat.
■
Do not install the unit in premises where it
may be subjected to water splashes (e.g.
laundry rooms).
■
To protect the climate unit from corrosion,
the unit must not be installed where it can be
directly exposed to seawater splashes or sul-
phur fumes.
Selection of installation location for indoor
unit
Caution
For optimum comfort, energy saving and func-
tion the unit should be positioned as recommen-
ded below.
Prevent the following:
■
Proximity to heat sources that can damage the unit's
cover.
■
The presence of oil vapour (such as in a kitchen or near
industrial machinery) because oil contamination can
lead to malfunction or deform surfaces, especially the
unit's plastic surfaces.
■
Premises with unstable surfaces can cause vibrations,
noise or water leaks.
■
To drill holes in enclosed areas where there are elec-
trical parts or units.
The following is recommended:
■
Select the appropriate position from which every angle
of the premises can be heated uniformly.
■
Check that the surface is sufficiently stable to carry the
weight of the unit.
■
Select a suitable position to ensure good ventilation
and maintenance space around the unit.
Installation area
Minimum working and maintenance range (measured
in mm):
To Next Page
Loading...
