From IR to wire
TIP
Wire transfer from the remote control to the
indoor unit is appropriate if one wants to posi-
tion the remote control in a place where the IR
signal between the units cannot reach.
To connect the remote control with a cable to the indoor
unit, prepare the remote control as follows:
■
Remove the plastic cover from the terminal block.
■
Open the battery compartment, remove the batteries
and set the DIP switches 5 and 6 in mode "OFF" mode.
■
Close the compartment without inserting the batteries,
the remote control will be supplied with power via the
cable.
Use a three core cable. The cable should be no more than
15 meters long.
Remove the yellow bracket and then connect the remote
control to the indoor unit as illustrated. See page 12 for
information on how to access the terminal block in AG-
WL10.
To Next Page
Loading...
