Volume: Volume output’s sound of the equipment. From 0 to 5.
Device ID (1-255): Number for device identification at the network. Can be addressed until
255 devices (whose IDs with values from 0 to 99999999).
Admin PIN Code: Administrator’s password. By default, it’s 12345 but it’s recommended
that this password be changed for one more stronger. To do this press the button to eraser
and enter the new one, and press OK to save the new password.
Web swicth: Embedded webserver for device setup.
Web port: Access port from HTML page. By default the port is 80, but if changed, the access
to the page must be made following this sequence: http://IP_C2PRO:NEW_PORT
Factory reset (FN): Reconfigure the equipment to the factory reset. (The whole memory is
reset).
Restart: Restart the equipment.
2 – Time
Configure the time and date fields according to your country using the numeric buttons.
Select the button Set to save the configuration.
If it’s necessary, configure the daylight saving time at the equipment. Configure the
beggining and the end by date or month/week.
To Next Page
Loading...
Need help?
General