76 Unidrive M/HS Frame 5 to 6 Power Installation Guide
Issue Number: 9
4.12.5 Compliance with generic emission standards
Use the recommended filter and shielded motor cable. Observe the layout rules given in Figure 4-17
and Figure 4-19. Ensure the AC supply and ground cables are at least 100 mm from the power
module and motor cable.
Figure 4-17 Supply and ground cable clearance (sizes 5 to 6)
Figure 4-18 Sensitive signal circuit clearance
Avoid placing sensitive signal circuits in a zone 300 mm (12 in) in the area immediately surrounding
the power module. Ensure good EMC grounding.
Do not modify
the filter wires
Sensitive
signal
cable
300 mm
(12 in)
To Next Page
Loading...
