Nidec F600 - Step 5: Remove the finger guard breakouts

F600 Step By Step Guide 8
STEP 5: Remove the finger guard breakouts
Removing the finger-guard break-outs
A
1
2
2
1
2
1
2
1
2
1
3
2
B
C
D
A: Size 3 to 11
B: Size 5 only
C: Size 6 only
D: Size 7 to 11
Place finger-guard on a flat solid surface and hit
relevant break-outs with hammer as shown (1).
For sizes 7 to 9 pliers can be used to remove the
break-outs, grasp the relevant break-out with the
pliers and twist it as shown (3). Continue until all
required break-outs are removed (2). Remove any
flash / sharp edges once the break-outs
are removed.
Finger guard grommets are supplied in the kitbox for
size 5 and 6.