Basic Photography and Playback 19
Zoom
The zoom control can be used to frame subjects
in the monitor or viewfinder. Select W to zoom
out, increasing the area visible in the frame.
Select T to zoom in up to 3.5× so that the subject
fills a larger area of the frame. The amount of
zoom is displayed in the monitor.
Holding the control to T at 3.5× zoom will trigger digital zoom, allowing the
subject to be magnified up to 4× more, for a total magnification of 14×.
A Digital Zoom
If possible, digital zoom will create a picture by cropping the area visible in the moni-
tor to the current image size (B 66), increasing magnification without affecting qual-
ity. If the crop would be smaller than the current image size, additional pixels are
added through a process known as interpolation, creating a slightly “grainy” image.
The amount of zoom available before interpolation is used depends on the option
currently selected for image size, as shown in the following table.
2 is displayed when interpolation is in effect. Using digital zoom at sizes of 3,648×
2,736 (j), 3,648×2,432 (h), or 3,584×2,016 (9) always triggers interpolation.
Zoom out Zoom in
Indicator is displayed
when zoom control is
pressed
Optical zoom
(up to 3.5×)
Indicator turns yellow
when digital zoom is in
effect
T
W
T
W
Image
size
Max. zoom without interpolation
Image
size
Max. zoom without interpolation
Digital zoom Total magnification Digital zoom Total magnification
f 1.4 × 4.9 × d 2.8 × 9.8 ×
g 1.6 × 5.6 × i 3.4 × 11.9 ×
e 2.2 × 7.7 × k 4.0 × 14.0 ×
To Next Page
Loading...
