Nikon Coolpix S610C - Appendix; Error Messages; Troubleshooting

52
Appendix
Error Messages
Display Problem Solution
A
N
Memory card is write
protected.
Write-protect switch is in
“lock” position.
Slide write-protect switch to
“write” position.
## of the
User’s Manual
q N
Battery exhausted.
Transfer terminated.
Battery exhausted during
picture upload.
Use the AC Adapter EH-63, or
charge the battery, turn the
camera on again, and apply
the last mode used for picture
upload.
## of the
User’s Manual
q P
SSID not found
SSID was not detected. • Signal strength may be poor.
Try the following and press
the k button.
-Be sure that your hand is
not obstructing the
camera’s antenna.
- Change the camera’s
direction.
- Move the camera closer to
the access point.
- Remove any obstacles
between the camera’s
antenna and access point.
• When Retry is displayed,
select Retry and press the
k button.
–
q P
Connection error.
Wireless connection to
the SSID was terminated.
Signal strength may be poor.
Try the following and press the
k button.
- Be sure that your hand is not
obstructing the camera’s
antenna.
- Change the camera’s
direction.
- Move the camera closer to
the access point.
- Remove any obstacles
between the camera’s
antenna and access point.
–
Q7115_Wireless_EN.book Page 52 Tuesday, June 3, 2008 7:34 PM
Appendix
53
Troubleshooting
q P
Connection error.
Connection to the server
failed, or error occurred
during picture upload.
• Select Resume and press
the k button to attempt
connection to the server
again.
• Choose Select SSID and
press the k button to select
SSID again.
49
q P
User information
incorrect.
Camera is not certified to
connect to the wireless
network.
Press the k button and select
SSID again. 49
q P
Server is full.
my Picturetown server is
full.
Delete unnecessary pictures
from the server.
–
q P
Service not available.
Cannot use
my Picturetown network
service.
Press the k button and select
SSID again. 49
q P
Address incorrect.
An error occurred with
Picture Mail recipient
e-mail address.
Be sure that you have specified
the recipient’s e-mail address
correctly.
34
q P
Login failed.
Login error occurred. • Select Re-enter and press
the k button to configure
Email ID and password
again.
• Select Select SSID and
press the k
button to select
SSID again.
28
49
Problem Cause/Solution
A
The camera is not detected by the
my Picturetown Utility.
Confirm your camera’s connection to the
computer.
15
SSID is not displayed. • Configure a network profile.
• SSID is hidden.
• Signal strength may be poor.
- Be sure that your hand is not obstructing
the camera’s antenna.
- Change the camera’s direction.
- Move the camera closer to the access
point.
- Remove any obstacles between the
camera’s antenna and access point.
17, 28
10
Display Problem Solution
A
Q7115_Wireless_EN.book Page 53 Tuesday, June 3, 2008 7:34 PM
Q7115_Wireless_EN_1st