Nikon Coolpix S610C - Configuring a Network Profile

Configuring the Camera’s Wireless Settings
28
a Configuring a Network Profile
Enable connection of the camera to the Internet via a wireless LAN access point. Follow
the procedures indicated below to apply the same network settings used by the
wireless LAN network to the camera. See “Configuring a Network Profile from the
Camera” (A 29) for more information.
If your wireless LAN access point supports WPS, configuring the network profile for a
home wireless LAN access point is simple (A 39).
B Six-Month Complimentary T-Mobile HotSpot Subscription (the United States only)
If using the six-month complimentary T-Mobile HotSpot subscription, a network profile has already
been configured with the camera. Be sure to proceed to “b Entering my Picturetown User
Information” (A 33) to set up the camera’s wireless settings.
D More on Configuring Network Profiles
Network profiles for wireless LANs can be configured (A 29) after pictures and recipients have been
selected under the following circumstances:
• The public wireless LAN access point does not utilize the IEEE 802.1X standard.
• Home wireless LAN access points are configured as follows:
- The access point’s SSID is set to “any” (to allow connection of any wireless device).
- MAC address filtering is not enabled.
- Data is encrypted using WEP encryption, or data encryption is not enabled.
- IP addresses are acquired automatically (DHCP).
2 Choose Configure manually.
3 Choose the desired SSID (network name) or enter a new SSID.
4 Choose the desired network type.
* See “Public Wireless LAN” ( A iv) for more information on countries in which public wireless LANs
can be accessed by, and the wireless service providers that support connection of, this camera.
1 Choose Network profile from the Wireless settings option in the
camera’s setup menu.
7 Specify the camera’s IP address.
8 Enter the user name and password.
5 Choose the desired authentication method.
6 Enter the encryption key.
Home wireless LAN Public wireless LAN*
Q7115_Wireless_EN.book Page 28 Tuesday, June 3, 2008 7:34 PM
Configuring the Camera’s Wireless Settings
29
Configuring a Network Profile from the Camera
1 Choose Network profile from the Wireless
settings option (A 26) in the camera’s setup menu
and press the
k button.
2 Choose Configure manually and press the k
button.
The camera will search for available SSIDs and then the SSID
selection screen will be displayed.
Wireless settings
Network profile
Sender
Address options
Picture Bank
Password
Configure manually
Push-button WPS
PIN-code WPS
Network profile
Cancel
Searching for SSID
Q7115_Wireless_EN.book Page 29 Tuesday, June 3, 2008 7:34 PM
Q7115_Wireless_EN_1st