Configuring the Camera’s Wireless Settings
32
7 Specify the camera’s IP address (A 10).
To acquire the IP address automatically, choose Auto and press
the k button.
To enter a fixed IP address, choose Manual and press the k
button.
Specify the IP address, Subnet mask, Gateway, Primary
DNS, and Secondary DNS settings (A 10).
When configuring IP address, Subnet mask, Gateway,
Primary DNS, and Secondary DNS settings, enter each set of
numbers so that they are aligned to the right. Numbers must be
entered correctly for the settings to be properly applied.
For information on entering text, see “Entering Text with the
Camera” (A 27).
Once all network settings have been configured, Done will be
displayed and the monitor display will return to the wireless
settings screen. If connecting via a home wireless LAN, network
profile configuration is complete.
To connect to another wireless LAN access point, repeat the
procedures described from step 1.
8 Enter user name and password (A 10).
Enter your user name in the user name screen and your
password in the password screen. Your user name and
password are provided by the wireless service provider to which
you subscribe (A iv).
For information on entering text, see “Entering Text with the
Camera” (A 27).
Once all network settings have been configured, Done will be
displayed and the monitor display will return to the wireless
settings screen. If connecting via a public wireless LAN, network
profile configuration is complete.
To connect to another wireless LAN access point, repeat the
procedures described from step 1.
When setting up the wireless LAN features of the camera for the first time, next enter
the information required for my Picturetown user registration. Proceed to “b
Entering my Picturetown User Information” (A 33).
Configuration
Auto
Manual
129010.168.
0 1 23456789
IP address
Back Delete
Done
abcdefghi jkl
n
m
opq r s t u vwx y
0
z
1 23456789
@
.
1286
Nik no1
User name
Back Delete
Done
Q7115_Wireless_EN.book Page 32 Tuesday, June 3, 2008 7:34 PM
Configuring the Camera’s Wireless Settings
33
b Entering my Picturetown User Information
Enter the information required for user registration with my Picturetown from the
Sender option. This information is necessary to log-in to my Picturetown after picture
upload. The alias and e-mail address are used to identify you as the sender in e-mail
notification sent to recipients with picture upload using Picture Mail.
If you have already registered with my Picturetown, use the same e-mail address and
nickname (alias) currently used by my Picturetown (A 43).
1 Select Sender from the Wireless settings option
(A 26) in the camera’s setup menu, and press the
k button.
2 Enter your e-mail address (up to 64 alphanumerical
characters).
Cellular telephone e-mail addresses are not supported.
No error message, or indication that an error has occurred, is
sent from the server when delivery errors occur due to incorrect
entry of e-mail addresses.
For information on entering text, see “Entering Text with the
Camera” (A 27).
3 Enter your alias (up to 16 alphanumerical
characters).
Once the alias has been entered, the confirm address and alias
screen will be displayed. Press the k button to apply the
settings and return to the wireless settings screen.
Wireless settings
Network profile
Sender
Address options
Picture Bank
Password
abcdefgh i j k l
n
m
opqr s t uvwx y
0
z
123456789
@
.
Nik no4
@
xxx
6410
Email
Back Delete
Alias
Back Delete
abcdefgh i j k l
n
m
opqr s t uvwxy
0
z
1234 56789
@
.
Nik no4
166
Q7115_Wireless_EN.book Page 33 Tuesday, June 3, 2008 7:34 PM
To Next Page
Loading...
