E55
Reference Section
Vibration Reduction
Select the vibration reduction option for shooting. Set Vibration reduction to
Off when using a tripod to stabilize the camera during shooting.
B Notes About Vibration Reduction
• Vibration reduction may take a few seconds to activate after the power is turned
on, or the camera enters shooting mode from playback mode. Wait until the image
of the monitor stabilizes before shooting.
• Images displayed in the camera monitor immediately after shooting may be
displayed blurry.
• Vibration reduction may be unable to completely eliminate the effects of camera
shake in some situations.
• Image processing with vibration reduction may not perform as expected with very
slight or extreme camera shake, even when On (hybrid) is selected.
• Image processing with vibration reduction is not enabled at fast or extremely slow
shutter speeds, even when On (hybrid) is selected.
• When On (hybrid) is selected, the image processing with vibration reduction
cannot be performed while using some scene modes, the special effects mode,
and the smart portrait mode.
• When On (hybrid) is selected and vibration reduction is activated, the shutter is
automatically released twice when an image is taken to allow for image
processing. Therefore, the time required to save images increases. Shutter sound
(E57) can be heard only when the shutter is released the first time and a single
image will be saved.
Display the shooting or playback screen M Press the d button M z Set
up M Vibration reduction
Option Description
V On (hybrid)
The effects of camera shake are reduced optically
using a lens-shift method. Additional image
processing with vibration reduction is applied to
further reduce the effects of camera shake with
saving of still images taken under the following
conditions:
• When flash is disabled
• When a shutter speed slower than 1/60 seconds
is used
• When Self-timer is disabled
• When Single is selected for the Continuous
setting
• When ISO sensitivity is set to 200 or less
g On (default setting)
The vibration reduction using the lens-shift method
only is enabled.
p Off Vibration reduction is not enabled.
To Next Page
Loading...
Need help?
General
