5
1
.3 Turn the battery pack latch to the locked position
Tip
1
.4 Check the battery indicator
Turn the camera on (A) and confirm the battery level in the control panel
on top of the camera (B).
Battery fully charged
Low battery
Ready a fully-charged spare battery. (The display in the viewfinder
turns off to save power when no operations are being performed.)
Battery exhausted
No photographs can be taken until the battery has been replaced.
All indicators in the viewfinder and rear control panel, and all indicators
in the top control panel other than the exposure mode, battery indicator,
and exposure counter, disappear six seconds after the camera is
turned on (automatic meter switch-off).
A B
First Steps: Insert the Battery
Reactivating the display
Lightly press (half-press) the shutter-release button to reactivate the display in the
control panel and viewfinder. Indicators will be displayed for six seconds after you
remove your finger from the button. Note that when using the shutter-release button
for vertical shooting, you will need to set the shutter-release button lock release for
vertical shooting to the unlocked position.
The length of time before automatic meter switch-off can be changed using custom
settings (see “Custom Settings,” item 15).
To Next Page
Loading...
