74
31.Sensitivity Up
By default, sensitivity can be set to a values equivalent to ISO 200, 400,
800, or 1,600. Sensitivity up can be used to increase sensitivity by a factor
of +1 or +2 over ISO 1600. These settings can be used to achieve high
shutter speeds at night-time sporting events, or to achieve optimal expo-
sure when taking photographs of poorly-lit subjects. Note, however, that
high sensitivity settings increase the amount of noise that appears in the
final photograph. It is recommended that you take a trial photograph to
check the results when shooting at high sensitivity settings.
Option: 0 Sensitivity can be set to values equivalent to 200, 400, 800, or
1,600 (default)
1 Sensitivity set to +1 (sensitivity display in rear control panel
shows HI-1)
2 Sensitivity set to +2 (sensitivity display in rear control panel
shows HI-2)
Quick Guide to Custom Settings Options
Copy the following table and keep it with your camera for reference.
Custom Settings: Custom Settings Options
6: Focus area
selection
7: AE lock
11: Auto exposure/
flash exposure
bracketing
12: Command dial
functions
13: Exposure
compensation
settings
Custom Setting Option Meaning Custom Setting Option Meaning
0: Custom settings
A Custom Set A
b Custom Set B
1: Image status
0 Disabled
1
Capture Preview
Mode
2
Record-and-Review
Mode
2: EV steps for
exposure
control
3
1
/
3
1 1
2
1
/
2
3: Bracketing
order
1 Negative-to-positive
0 Default
4: Autofocus
activation
0
1
Shutter-release
button activates AF
AF activated by
button only
5: Anti-vibration
mode
0 Disabled
1 Enabled
1 Wrap-around
0 Default
0
Only button
locks AE
1
AE locks when
shutter-release
button pressed half
way
8: Mirror up
0 Mirror down
1 Mirror up
9: Dynamic AF
mode (single-
servo AF)
0
Closest subject
priority enabled
1
Closest subject
priority disabled
10: Dynamic AF
mode (continu-
ous-servo AF)
0
Closest subject
priority disabled
1
Closest subject
priority enabled
AS
Flash and auto
exposure
AE Auto exposure only
Sb Flash exposure only
0 Default
1
Roles of main and
sub command dials
reversed
0 Default
1
Exposure compen-
sation set by turning
main or sub com-
mand dial
To Next Page
Loading...
