56
Capture Preview Mode
When the camera is set to single-frame shooting, or the self timer is used, you
can use capture-preview mode to view photographs in the LCD monitor before
they are saved to the memory card. This makes it possible to delete unwanted
photographs before they are saved.
To use capture preview:
1
Pressing the button, rotate the main command dial to select item 1 in
the custom settings menu (at default settings, “1-0,” for “Item 1, option 0,”
will be displayed in the rear control panel).
2
With the button held down, rotate the sub-command dial to set the
menu option to “1” (“capture-preview mode enabled”).
When you release the button, CUSTOM will be displayed in the rear
control panel.
3
Set the camera to single-frame shooting or self-timer mode.
Photographs taken at these settings will be displayed in the LCD monitor
before they are saved to the memory card. If the camera has been set to
display the histogram and image highlights (see “Playback”), these will be
shown as well. If the camera is connected to a television set, photos will
also be displayed on the television screen.
Camera Settings: Capture Preview Mode
To Next Page
Loading...
