Nikon D300 - Points to Notice for Disassembly and Assembly; Points to Notice for Lead-Free Solder Products

- Ｄ  ･ -
logo�Q0310�forGraphic
070509�Gdesign�ito
VBA20001-R.3720.A
Caution:
① In disassembly/(re)assembly, be sure to use conductive mat (J5033) and wrist strap (J5033-5), in
order to protect electric parts from static electricity.
② Before disassembling, be sure to remove batteries or AC power cord.
③ 
their types, etc.
④ .
⑤
is indicated in this manual when NK screw is used. Usually the same "NK" screw can be used


ＮＫ
Points to notice for Disassembly and Assembly
WARNING

covers.
After removing covers, b
e
sure to discharge the main
condenser according to the instructions of repair manuals
.
Caution:
When "Separation of Front body from Rear body", "Disassembly of CCD/FPC unit" and
"Disassembly of Bayonet" are performed, be sure to carry out "RESET AF-DEFOCUS
COMPENSATION" of the D300 adjustment software after assembly.

・ 
・ For soldering work, the special solder and soldering iron are required.
・ 
・ Use the special soldering iron respectively for lead-free solder and lead solder.
They cannot be used in common.
INC