VBA20001-R.3720.A
- Ａ ・ -
logo�Q0310�forGraphic
070509�Gdesign�ito
Start adjustments
・Provide the power for the camera via AC adapter.
・Reset "Custom setting".
・Set "PTP" mode by Setup menu.
・
・Connect the camera and PC via USB cable.
・Set the luminance of the color viewer to LV13 equivalent.
・Set the shutter tester to LV9.
Based on the procedure of the image adjustment software,
with two-dimensional barcode reader and write the image sensor-unique data into the DG-PCB.
※ Set the settings of the two-dimensional barcode reader. (ref. Page A53)
※
image sensor holder unit.
・When the image sensor holder unit is replaced, or the DG-PCB unit and the image sensor holder unit are
・When the DG-PCB unit is replaced,
attached to the body.
8. Procedure
8-1. Shooting image adjustment
beforehand, then perform the adjustments. (ref. 9-4.)
Note: Adjustments are not possible without resetting "Custom setting" of this camera.
Before the adjustments, record the details of "Custom setting" set by customers if necessary.
【】
＊ Perform "".
code on the playback screen can be read out with two-dimensional barcode reader.
【Shooting condition】
Compact digital camera is used:
・
・Size: 3M
・Shooting mode:BSS
・AF mode: Closeup mode
・SB mode: Flash cancel
To Next Page
Loading...
