Nikon D7000 - Page 146

126
r
❚❚ Copying White Balance from d-0 to Presets d-1–d-4
Follow the steps below to copy a measured value for white balance from d-0 to any
of the other presets (d-1–d-4).
1 Select L (Preset manual).
Press the G button and select White
balance in the shooting menu.
Highlight
Preset manual and press 2.
2 Select a destination.
Highlight the destination preset (d-1 to d-4)
and press W.
3 Copy d-0 to the selected preset.
Highlight Copy d-0 and press J. If
comment has been created for d-0 (0 129),
the comment will be copied to the comment
for the selected preset.
❚❚ Copying White Balance from a Photograph (d-1–d-4 Only)
Copy a value for white balance from an existing image to a selected preset. Note that
existing values can not be copied to preset d-0.
1 Select L (Preset manual).
Highlight Preset manual in the white
balance menu and press 2.
2 Select a destination.
Highlight the destination preset (d-1 to d-4)
and press W.
G button
W button
W button