Nikon DS-5M - Using Telnet Commands to Operate on the DS-L1

VI Basic Operations NETWORK
4 Using the DS-L1 via a Network
- 97 -
4.5
Using Telnet Commands to Operate on the DS-L1
You can use Telnet commands to operate the DS-L1 from your PC.
NOTE: Always be sure to consult the network administrator in your organization
before executing Telnet commands. Your organization’s network may have
been set up in a unique manner, so invalid operations could cause a
problem on your network.
Enter the IP address of the DS-L1 from the MS-DOS prompt (command prompt) of
Windows to connect to the DS-L1.
(Example: Telnet 192.168.10.2)
Commands
W_LCA_(space) 32 characters
Allows you to register the Location information to be displayed on the WEB screen.
W_IPA_
Allows you to register the connectable IP addresses.
A detailed command list is available from Nikon. If you wish to have one, please
contact your nearest Nikon representative.