Nikon DTM Series - 5-3. Commands;Data Format

Nikon Communication Interface Manual
P7/34
5-3. Commands/Data format
Three types of commands are available;
a) Remote control command: Change function. Most commands do not follow any data output.
b) Data set command: Set instrument settings such as temperature, pressure etc. No data output follows.
c) Data output command: Output measured data, setting data etc. Follows data output.
Keyword
Remote control command “$”
Data set command “!”
Data output command: “?”
Each command consists of a keyword, three characters. Parameters are added when necessary.
Keyword
($/!/?)
Char-1 Char-2 Char-3 Parameter…
An asterisk is added in front of the keyword when the extended command is to be used.
*
Keyword
($/!/?)
Char-1 Char-2 Char-3 Parameter…
Confidential