Nikon Communication Interface Manual
P9/34
!BSE Set station coordinate data (HI & Stn-XYZ) and HT.
!SOD Set a set of stakeout data (by HA+HD) and jump to the Stakeout screen
!SOC Set a set of stakeout data (by 9-digit coordinates) and jump to the Stakeout screen
!TGT Set the type of measuring target (Prism/Sheet or Prism/N-Prism)
*!PNO Set a point number. (16-digit PT)
*!HAN Set the current horizontal angle (by 8 digits)
*!SOC Set a set of stakeout data (by 12-digit coordinates) and jump to the Stakeout screen
*!BSE Set station coordinate data (HI & Stn-XYZ) and HT. (by 12-digit coordinate)
*!H-T Set a height of target. (by 7 digits)
C) Data Output Commands
Command Remarks
?CND Output a set of initial settings on the instrument
?VAN Output the current vertical angle (by 9 digits)
?HAN Output the current horizontal angle (clockwise; by 9 digits)
?HRV Output the current horizontal angle (counter-clockwise; by 9 digits).
?SDS Output the current slope distance
?HDS Output the horizontal distance
?VDS Output the vertical distance
?PSM Output the current prism constant value
?PNO Output the current default point number/name (in 7 digits)
?T-P Output the current temperature and pressure
?BAT Output the current battery level
?AVE Output the average count of measurement
?BSE Output the current station coordinate (HT/HI/Stn-XYZ) on the instrument
?CDR Output a coordinate
?SOD Output a set of stakeout data (by HA+HD)
?SOC Output a set of stakeout data (by 9-digit Coordinate)
?LPT Output the status of the Laser pointer.
*?PNO Output the current default point number/name (16-digit PT)
*?BAT Output the current battery level (in 16 levels)
*?CDR Output coordinates (in 12-digit)
*?SOC Output a set of stakeout data (by 12-digit coordinates)
*?BSE Output the current station coordinate(HT/HI/Stn-XYZ) (in 12-digit coordinate)
*?H-T Output the height of target (in 7 digits)
To Next Page
Loading...
Need help?
General
