104
Lamp (continued)
Problem
The brightness of the
lamp does not change
even though the
brightness control
switch is pressed.
The brightness of the
lamp does not change
even though the
brightness control
switch is pressed.
(For the simultaneous
illumination)
The brightness of the
lamp does not change
even though the
brightness control
switch is pressed.
(For the external light
source)
The brightness of the
illumination changes
when objectives or filter
cubes are changed.
The brightness of the
illumination does not
become a suitable level
even though objectives
or filter cubes are
changed.
Countermeasure
Perform the setup works for the
microscope. (p. 36)
Perform the setup works for the
microscope. (p. 36)
Connect the control cable correctly and
turn the EXTERNAL switch to the ON
position. (p. 88)
Perform the setup works for the
microscope. (p. 36)
Connect the RS-232C cable. (p. 90)
Disable the interlock controls.
(Refer to “LV Series Support
Tools software manual.”)
Perform the setup works for the
microscope. (p. 36)
Enable the interlock controls.
(Refer to “LV Series Support
Tools software manual.”)
Perform the setup works for the
microscope. (p. 36)
Cause
The lamp information is not registered
correctly.
The information of the external power
supply is not registered correctly.
The power supply is operated manually.
The information of the light source is
not registered correctly.
The light source is operated manually.
Interlock controls are enabled.
The information of the microscope
configuration is not registered correctly.
Interlock controls are disabled.
The information of the microscope
configuration is not registered correctly.
To Next Page
Loading...
Need help?
General
