EasyManua.ls Logo

Nikon Eclipse LV100DA-U - Microscope (LV100 DA-U) Specifications

Nikon Eclipse LV100DA-U
115 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
108
Model name
Optical system
Illumination
Built-in power supply
for the illumination
lamp
Focusing mechanism
Eyepiece
Interface
Input ratings
Power cord
ECLIPSE LV100DA-U
CFI60 system (chromatic aberration free infinity optics system)
Episcopic illumination: Built-in type lamp power supply, NCB11, ND4, and ND16 are
installed. (exchangeable)
Specified illuminator:
LV-UEPI2A Motorized Universal Epi Illuminator 2A
Diascopic illumination: Built-in type lamp power supply, fly’s eye lens, NCB11 and
ND8 are installed. (not exchangeable)
Output: One line (epi/dia selection type, simultaneous illumination is
available when used with an external power supply)
Output voltage: 12 VDC, 50 W, 4.4 A maximum
Voltage control range: 1 to 12 V (independent control for epi and dia)
Lamp ratings: 12 VDC, 50 W halogen lamp
Specified lamp: LV-HL50W 12 V 50 W LONGLIFE Halogen Lamp
Specified lamp house: LV-LH50PC Precentered Lamp House
Manual operation type single axis coarse/fine focus knob mechanism
(left side with coarse/fine focus, right side with coarse focus, calibration marking for fine
focus: 1 µm/marking)
Stroke: 40 mm with coarse focus stopper mechanism
Coarse focus knob: 14 mm/revolution
Fine focus knob: 0.1 mm/revolution
10x, field number: 22, 25
UEPI2A connector: for LV-UEPI2A epi illuminator
USB connector: for PC to perform setup work, for the DS-L2 (USB 1.1
compatible)
RS-232C connector: for external light source
LCNT connector: for external power supply for lamp (for simultaneous
illumination)
Input voltage: 100 to 240 VAC ±10%, 50/60 Hz
Rated current: 1.2 A maximum
When the supply voltage is 100 V to 120 V:
UL Listed detachable cord set, 3 conductor grounding Type
SVT, No.18 AWG, 3 m long maximum, rated at 125 VAC
minimum
When the supply voltage is 220 V to 240 V:
Power cord set approved according to EU/EN standards, 3
conductor grounding Type H05VV-F, 3 m long maximum,
rated at 250 VAC minimum
For Japan:
Power cord set approved according to the Electrical Appliance
and Material Safety Law (with the PSE mark)
(3 conductor grounding Type VCTF 3x0.75 mm
2
, 3 m long
maximum, rated at 125 VAC minimum.)
Specifications
LV100DA-U

Table of Contents

Related product manuals