55
III. Operation of Each Part
Slide condenser
When the slide condenser is used, vignetting in the field
is seen with the 2.5x objective: therefore, the slider
should be kept inserted. When the 5x or higher
objective is used, the slider should be pulled.
ND8
NCB
F. S.
7
5
3
7
0
1
J
A
P
A
N
Ac
hr
N.A =
0.9
JAPAN
0.8
0.7
0.6
0.5
0.4
0.3
0.2
0.1
3
x
2 S
T
A
G
E
JA
P
A
N
Slider
Universal condenser
The universal condenser has a condenser turret for
switching the optical elements (modules) inside the
condenser. Rotate the condenser turret to change
microscopy methods under the diascopic illumination.
There are seven click-stop positions on the condenser
turret, which a label corresponding to each module is
affixed on. To place the desired module into the optical
path completely, rotate the condenser turret to the click-
stop position where the label corresponding to the
desired module faces front.
ND8
N
CB
F.S.
J
A
PA
N
69
6
0
0
1
3
x
2
ST
AGE
J
A
P
A
N
Condenser
turret
lebaL eludoM noitacilppA
0)eludomon(elohytpmE
rednuypocsorcimdleif-thgirbehtrofeludomsihttceleS
.noitanimullicipocsaideht
3hP~1hPmgarhpaidralunnahP
edochPehtotgnidnopserrocseludomehtfoenotceleS
ehtrednuypocsorcimhPehtrofevitcejboehtfo
ehtretnec,nemicepsaevresbooT.noitanimullicipocsaid
1*.evitcejboehtfogniretalpesahpehtrofmgarhpaid
x4-2snelyrailixuax4-2
ypocsorcimdleif-thgirbehtmrofrepoteludomsihttceleS
x4otx2ehthtiwnoitanimullicipocsaidehtrednu
.sevitcejbo
FDmgarhpaidralunnadleifkraD
ypocsorcimdleif-kradehtmrofrepoteludomsihttceleS
.noitanimullicipocsaidehtrednu
RN,2N,1NmsirpCIDresnednoC
evitcejboehtotgnidnopserrocseludomehtfoenotceleS
cipocsaidehtrednuypocsorcimCIDehtmrofrepot
2*.noitanimulli
*1 For details about centering the Ph annular diaphragm, see the instruction manual for the LV-CUD.
*2 For the combination between the prisms and objectives, see Page 62.
For details about the universal condenser operation, the microscopies with the condenser,
and the module installation into the condenser, see the instruction manual for the LV-CUD.