AUTOMATIC
BALANCED
FILL-FLASH
When the S8-24 is turned off and the scene's brightness is
EV10
or higher, if the computer's multi
-s
egment sensor detects
that the central subject is darker than the surrounding area by
at least 1.
5EV
, the viewfinder ready-light
LED
blinks, recom-
mending that you should use flash to brighten the picture.
(Note: the S8-24 must
be
turned off for this signal to operate.
The
LED
will not blink with the S8-24
in
ST8Y or
ON
mode.)
Set the camera for Program exposure control and the S8-24 for
TTL exposure control. A balanced fill-flash picture will result,
automatically. It's that easy.
When using the
S8
-
24
or any other flash
in
the
F-401
s/N4004s
hot shoe, built-in speedlight must remain
in
the down position.
You
cannot use both speedlights at the same time. Using the
S8-24 relieves the camera's power supply from operating the
built-
in
flash, and you can expect the camera's motor to be able
to power more rolls of film.
56
Fd'J
®
0.
60
.
811.52
346
91318m
2 3 4 5 7
1015
20
304060
ft
zoo'l:1
mm
F
To Next Page
Loading...
